Refill a vape pod step by step:
-
Step 1: Remove the pod from the e-liquid battery and locate the rubber stopper covering the filling port.
-
Step 2: Lift the rubber stopper to reveal the filling hole, then insert the nozzle of the e-liquid bottle into the hole.
-
Step 3: Slightly tilt the pod to prevent air pockets and slowly fill it with e-liquid.
-
Step 4: Leave a small air bubble at the top of the pod and seal the filling hole with the rubber stopper.
-
Step 5: Wipe off any excess e-liquid around the pod and reattach it to the battery.
Refilling a bottom fill vape tank step by step:
-
Step 1: Unscrew the tank from the e-cigarette battery and then unscrew the base from the tank.
-
Step 2: Place the nozzle of the e-liquid bottle into the filling hole located on the side of the tank, avoiding the central chimney. Do not pour e-liquid through the center hole.
-
Step 3: Slightly tilt the tank at an angle to prevent air bubbles, and slowly squeeze the e-liquid bottle to fill the tank.
-
Step 4:Leave a bubble at the top to ensure no e-liquid spills from the central chimney, then replace the base of the tank and tighten it by hand only.
-
Step 5: Wipe off any excess e-liquid around the bottom of the tank, then reattach the tank to the e-cigarette battery.
Refilling a top fill vape tank step by step:
-
Step 1:Unscrew or slide the top of the tank (depending on whether the tank twists or slides) to locate the e-liquid filling port.
-
Step 2:Insert the tip of the e-liquid bottle into the filling port.
-
Step 3:Slightly tilt the e-cigarette tank to prevent air bubbles, slowly squeeze the bottle to fill the tank, and leave a bubble at the top.
-
Step 4:Screw the top of the tank back on (or slide/twist it back into place) and wipe off any excess e-liquid.
You can also try mixing two types of e-liquids. Before trying, please make sure to thoroughly clean your vapes tank or pod to avoid any residual liquid affecting the flavor you're mixing.
Here are some tips for you:
-
First Way:
Warm the device to loosen the oil. You can do this, for example, by holding the vape in front of a heater vent for a few minutes. This is important because some vape oils are extremely thick and it'll be hard to get the oil into the syringe when it's cold.
-
Second Way:
step 1 Disassemble all the components of the tank or pod
step 2 Rinse and each component under warm running water to remove any e-liquid residue
step 3 Clean with mild soap and Rinse again
step 4 Dry thoroughly and reassembling the tank or pod carefully, making sure all components are properly fitted.
If you need to customize Vape Oil Pen Box, Pls click here!
